×
×
×
Standard BioTools Instrument Support
Jump to videos
Standard BioTools Tutorial Videos
Search
Helios System Tutorials
Helios: Torch Alignment Check Videos
STEPS 1-4 *NOTE: Have the torch alignment tool and the load coil spacer on hand prior to beginning this procedure. → Step 01...
Nov-09-2021
Helios: Removing, Cleaning and Reinstalling the Vacuum Cones
STEPS 1-9 → Step 01: Open the instrument front access door. → Step 02: The cone removal tool has two ends. One end is used ...
Nov-09-2021
Helios: Replace the Sample Probe Line on the Sample Loader
REMOVE THE SAMPLE PROBE LINE: Before beginning the procedure, have on hand: - Sample Probe Line (PN 107033) *NOTE: Disconnect...
Nov-09-2021
Helios: Torch Assembly Removal and Re-insertion Procedure | Duration 3:16
Mar-23-2021
Helios: Replace the Load Coil
STEPS 1-8 → Step 01: If the Load Coil (PN 105398) is damaged or misshapen, it must be replaced. Visit our store at https://st...
Nov-09-2021
Helios: Torch Removal, Cleaning and Reassembly Videos
STEPS 1-8 *NOTE: Prior to beginning the procedure have the following on hand: - 10% Contrad™ - Glassware brushes (Restek® PN 2...
Nov-09-2021
Helios: Sample Loader Daily Cleaning Procedure
SAMPLE CAPILLARY *NOTE: Prior to beginning the procedure have the following on hand: - Luer Adapter (PN 102183) - Union Body ...
Nov-09-2021
Helios: Sample Capillary Assembly: Nebulizer Sample Inlet End
STEPS 1-9 Before beginning, remove the following from the kit: - Yellow front ferrule - Stainless steel back ferrule - 1/16 in...
Nov-09-2021
CyTOF 2/Helios: Changing the Interface Pump Oil
STEPS 1-7 *NOTE: Perform this procedure before the instrument is turned on. → Step 01: Switch off the RF generator power usin...
Nov-30-2021